Table of Contents
Advertisement
LCD Messages
Problem/Symptom
Poor voice quality
Register failed
LCD Messages
Local Menu Configuration Messages
The following messages may be displayed in the LCD when accessing the
IP 710 phone's menu:
Message
conf timeout!
conf exception!
Saved!
Write Fail!
36 IP 710 Manual
•
Make sure a switch is used, rather than a hub, in the
corporate LAN.
•
G.711 provides better voice quality.
•
If VoIP is set up over WAN, set priority queuing on
the WAN router.
•
Make sure WAN QoS is okay by pinging a few
hundred packets from remote site and observe
packet loss and network latency.
•
Adjust jitter buffer to accommodate network
latency.
•
Check to make sure the extension number and
extension password are set up properly and that the
IP extension is enabled.
•
Check to make sure the IP Phone Service is started
in AltiWare.
•
If IP phone is associated with a physical phone (with
the same extension number), use #27 to activate the
IP phone to normal operating mode.
Explanation
After 2 minutes inside the configuration menu, if no
action is taken, the LCD will show this message and then
quit the menu.
During configuration, an unknown exception occurred.
The changed configuration was saved into memory.
Error occurred when saving the changed options into
flash ROM.
Solution
Advertisement
Table of Contents
