PWR
GND
PWR
AXP
AXM
GND
FIG. 10 AXlink 12 VDC power supply wiring example
If you are using power from AXlink, disconnect the wiring from the Axcess Control
System before wiring the AXB-TM5.
Use a 12 VDC power supply when the distance between the control system and AXB-TM5 exceeds
the limits described in the Wiring Guidelines section on page 4. Make sure to connect only the
GND wire on the AXlink connector when using a 12 VDC power supply. Do not connect the PWR
wire to the AXlink connector's PWR (+) terminal.
IRX-SM connections
Connect one or more (eight maximum in parallel) optional IRX-SM sensors to the AXB-TM5 as
shown in FIG. 11. You can also use TX-series wired control panels.
To IRX-SG
FIG. 11 IRX-SM connections
This configuration is for 40 kHz operation only.
AXB-TM5 Television Manager
GND
IN
AUX
PWR
Connection and Wiring
12 VDC power
supply
PWR
AXP
AXM
GND
GND
OUT
IRX-SM #2
AUX OUT
+12 VDC
GND
OUT
IRX-SM #1
AUX OUT
+12 VDC
7