Table of Contents
Advertisement
Connection and Wiring
Device DIP Switch
The eight-position Device DIP switch, shown in FIG. 2, sets the AXlink device number. Every
device on the bus must have a unique device code. An eight-position DIP switch is used to set the
device number for the AXB-TM5. The device number must match the number assigned in the
Axcess software program. The AXlink device number range is 1-255 and is sent according to the
Device DIP switch positions and their values.
After setting the AXlink device number, remove and reconnect the AXlink connector
on the AXB-TM5 to store the new number into memory.
As an example, FIG. 2 is set to 85 (1 + 4 + 16 + 64 = 85), which is the factory default setting.
FIG. 2 Device Code DIP switch setting example
The following table describes the Device Code DIP switch settings and its corresponding DIP
switch arrangements.
Device DIP switch settings
Position
Value
The device number takes effect only on power-up. If you later change the device
number, remove and reconnect the AXlink connector. This enters the new device
number into memory.
AMX standard device numbers are assigned as follows:
!
!
!
AXB-TM5 Television Manager
1
2
3
1
2
4
Cards are 1 through 25.
Boxes are 96 through 127.
Panels are 128 through 255.
4
5
6
8
16
32
Connection and Wiring
7
8
64
128
3
Advertisement
Table of Contents
