Table of Contents
Advertisement
Heritage Series ADSL Bridge/ Router
Command Sets for Command Line Interface
driver. Normal limits are 0 only for port, 0 only for VPI, 1..1023 for
VCI. If a single argument
torn down. This is equivalent to
state machine, providing a link of this form causes the link to be 'up'.
Note that
must also be used, to allow the link to become
enable
operational. The
ip
over the connection: one of IP data (controlled by the IPCP protocol),
or MAC data (for BCP). If neither is provided,
channel is not linked to an interface, and the channel is for IP data, the
channel is linked to interface 1. If the channel is not linked to an
interface, and the channel is for MAC data, the channel is linked to
interface 2. Providing a PVC setting unsets any SVC setting. See the
command. It is possible for a PVC to become 'down' in the PPP
svc
state machine even though the PVC is still there, for instance due to
an authentication failure. If in this state, an incoming packet will
cause the PPP state machine to go 'up'. If
the server end of a PVC. It will not send out PPP Configure Requests
until it first receives a packet over the PVC. When a connection is torn
down it goes returns to this state. Use the
information.
Configuration saving saves this information. By default a channel has
no connection information.
Example:
> ppp 3 pvc 3 32
> ppp 4 pvc
> ppp 5 pvc 0
16. <channel> qos
Syntax:
<channel> qos [cbr|ubr] [pcr <pcr-tx> [<pcr-rx>]]
Description:
Specify that the VC for a PPP channel should be Constant Bit Rate or
Unspecified Bit Rate, and (optionally for UBR) give a Peak Cell Rate
for the connection. If two values are specified then they are transmit
and receive PCRs respectively. If called while not attached to a VC
then the settings are saved for use when a VC is created. If the
channel is already attached to a VC then it is closed, and re-opened
with the new values. If it cannot be reopened, it remains closed.
Configuration saving saves this information. By default channels are
is supplied, any current connection is
none
on the channel. In the PPP
svc none
or
indicates which form of data is transported
mac
listen
info
set channel 3 to be (VPI=3,VCI=32)
;
read PVC settings for channel 4
;
remove any PVC settings from
;
channel 5
7-47
is assumed. If the
ip
is specified then this is
command to read this
Advertisement
Table of Contents
