Table of Contents
Advertisement
Heritage Series ADSL Bridge/ Router
Command Sets for Command Line Interface
DSL> ip device
# type dev file IP address
device ether ether //nice mtu 1500 192.168.2.1
device vlane ether //lane mtu 1500 192.168.56.3
6. get
Syntax:
get <file>
Description:
Reads and executes commands from a file. The commands in the file
are in the same format as those documented in this chapter, with no
"ip" prefix. They can contain comments, introduced by the "#"
character. The "get" command is "hidden", not shown by "ip
help".
Example:
DSL> ip get //isfs/cmdfile
7. ipatm abort
Syntax:
ipatm abort <n>
Description:
Closes an IP-over-ATM SVC; the number <n> is as displayed by
"ipatm files". If there is still traffic being sent to the destination
concerned, IP will soon open a new SVC to the destination.
Example:
DSL> ip ipatm abort 14
8. ipatm arp
Syntax:
ipatm arp [list]
Description:
Lists the cached mappings from IP addresses to ATM addresses; only
relevant when using IP-over-ATM with SVCs. (The "list" parameter is
optional and makes no difference to the behavior.)
Example:
DSL> ip ipatm arp
192.168.5.72 47.00.83.10.a2.b1.00.00.00.00.00.00.00.00.20.2b.01.00.07.00
192.168.5.33 47.00.83.10.a4.00.00.00.00.00.00.00.00.00.20.2b.01.00.19.00
192.168.5.111 47.00.83.10.e2.00.00.00.20.2b.01.01.a8.00.20.2b.01.01.a8.00
9. ipatm arpserver
Syntax:
ipatm arpserver [<i/f> [<ATM address>|here]]
7-25
Advertisement
Table of Contents
