Internal Programming Jumper; Light Flash Jumper - Avital 3300L Installation Manual

internal programming jumper

light flash jumper

This jumper is used to determine the light flash output. In the (+) position, the on-board relay is enabled and
the unit will output (+)12V on the H1/11 WHITE wire. In the (-) position, the on-board relay is disabled. The
H1/11 WHITE wire will supply a (-) 200 mA output suitable for driving factory parking light relays. To access the
jumper, open the control module.
NOTE: For parking light circuits that draw 10 amps or more, the internal jumper must be switched
to a (-) light flash output. P/N 8617 or a standard automotive SPDT relay must be used on the
H1/11 light flash output harness wire.
24
NOTE: JUMPER IS
INSIDE THE CASE
2008 Directed Electronics, Vista CA - all rights reserved