Table of Contents
Advertisement
H1/8 GREEN (-) door trigger input, zone 3
Most vehicles use negative door trigger circuits. Connect the green wire to a wire which shows ground when any
door is opened. In vehicles with factory delays on the domelight circuit, there is usually a wire that is unaffected
by the delay circuitry. This wire will report Zone 3.
H1/9 BLACK/WHITE high current output from on-board interior light illumination relay
Connect this wire directly to the domelight circuit in the vehicle. The on-board relay will drive circuits up
to 20 amperes. The polarity of this output is determined by the connection of the H2/G input wire in the Door
Lock Harness.
NOTE: If the H2/G input wire is not connected, there will be no output on this wire.
H1/10 WHITE/BLUE (-) channel 3 output
When the system receives the code controlling Channel 3, the white/blue wire will supply an output as long as
the transmission continues. Use for options such as 561T Valet Start system, 529T or 530T power window con-
trollers, etc.
IMPORTANT! Never use this wire to drive anything except a relay or a low-current input! The tran-
sistorized output can only provide 200 mA of current, and connecting directly to a solenoid, motor,
or other high-current device will cause it to fail.
2008 Directed Electronics, Vista CA - all rights reserved
7
Hide quick links:
Advertisement
Table of Contents
