Mpa External Detector Alarm Display - Bosch FAP-DO420 Operation Manual

28 en | Accessories
5.
Technical data
Operating voltage
Weight
Display medium
Permissible wire gauge
Maximum current consumption
6.7.2

MPA External Detector Alarm Display

Installation note
–
–
–
Notice!
i
The flat side of the prism (see Installation note, page 28, item Y) must follow the observer's
line of sight.
Figure 6.1: Installation of the MPA External Detector Alarm Display
Connection
The MPA is connected via four Wago terminals.
12/2012 | 8.1 | F.01U.003.448
Place the cap on the base plate in such a way that the two hooks (item A) are inserted
into the slits. Press the cap lightly onto the base plate until the snap-fit hook (item C)
engages.
Fitted directly to the wall or ceiling.
To feed cables through for surface mounting, punch out the prepared entry points (see
Installation note, page 28, item X) on the housing.
For flush-mounted cable insertion, feed the cable through the opening beneath the
connection board.
60
1 2 3 4
55
Operation Guide
Automatic Fire Detectors LSN
5–30 V DC
45 g
2 LEDs
0.6–2 mm
20 mA
85
A
Y
Y
Bosch Sicherheitssysteme GmbH
improved
X
A