Detector Removal; Addressing - Bosch FAP-DO420 Operation Manual

Automatic Fire Detectors LSN
improved
1
X
X
Figure 5.1: Activation of the removal protection mechanism
Key
1
2
3
5.6

Detector Removal

Unlocked detector heads are disassembled by turning them to the left and removing them
from the base.
Locked detector heads are disassembled by inserting a screwdriver into the unlocking opening
(Y) so that the bolt is pushed upward; at the same time, the detector head should be turned
to the left (see , page 23).
Figure 5.2: Detector removal (locked detector module)
5.7

Addressing

There are three rotary switches on the bottom of the detector; these are used to select
automatic or manual address allocation with or without auto-detection.
The following settings are possible:
Bosch Sicherheitssysteme GmbH
2
Bolt (X) before breaking out
Bolt (X) fitted, but deactivated
Locking activated
Y
Operation Guide
X
Connection | en
3
X
12/2012 | 8.1 | F.01U.003.448
23