Fap-Dot420 / Fap-Ot 420 - Bosch FAP-DO420 Operation Manual

12 en | Programming
Selectable installation locations in
the programming software (WinPara
and FSP‑5000‑RPS)
EDP room
Production location
Garage
High storage warehouse without
vehicle traffic with combustion
engine
Conference hall/waiting room/
fairground
Kitchen/casino/restaurant during
active operation
Warehouse with vehicle traffic
Rate of rise only (optical sensor off)
Optical only (thermal sensor off)***
Fixed temperature heat only (optical
sensor off)
Optical/chemical (thermal sensor
off)***
Schools/kindergarten
Theater/concert hall
O = optical sensor (dual-optical in FAP-DOTC420 detectors)
T = thermal maximum unit
max
T = thermal differential unit
diff
C = chemical sensor
* If optical sensor sensitivity is low, the detector will only trigger if smoke as well as an
increase in CO concentration or temperature is detected.
*** For FAP-DOTC420: does not comply with EN54-7
For details on installation height, see FAH-T 420/FAH-T 420-KKW, page 14
4.2 FAP‑DOT420 / FAP-OT 420
Notice!
i
The default setting of the FAP-DOT 420 and FAP-OT 420 detector types in RPS and WinPara is
"Office (day mode)". For a description of this setting, see the below table.
12/2012 | 8.1 | F.01U.003.448
Detector Type Sensitivity
Thermom
ax (T
max
O, T , T , C High (A2)
max diff
O, T , T , C Low (B)
max diff
O, T , T , C High (A2)
max diff
O, T , T , C Low (B)
max diff
O, T , T , C High (A2)
max diff
O, T , C Low (B)
max
O, T , T , C Low (B)
max diff
T , T High (A2)
max diff
O -
T High (A2)
max
O, C -
O, T , T , C High (A2)
max diff
O, T , T , C High (A2)
max diff
Operation Guide
Optical Chemical
) (O) (C)
High High
Low* Medium
Low* Low
High High
Low* Medium
Low* Low
Low* Low
- -
Low -
- -
Low High
Medium High
Medium High
Automatic Fire Detectors LSN
improved
Bosch Sicherheitssysteme GmbH