AVENAR detector 4000
1
X
X
Figure 5.1: Activation of the removal protection mechanism
Key
1
2
3
5.6
Detector Removal
Unlocked detector heads are disassembled by turning them to the left and removing them
from the base.
Locked detector heads are disassembled by inserting a screwdriver into the unlocking opening
(Y). At the first time removing the detector, push the screwdriver hard through the plastic to
get to the bolt. Push the upward and turn the detector to the felt at the same time.
Figure 5.2: Detector removal (locked detector module)
See also
–
5.7
Address Setting
The versions for automatic and manual address setting have three rotary switches on the
bottom of the detector; these are used to select automatic or manual address allocation with
or without auto-detection. The versions without rotaries are automatically addressable only.
The following settings are possible:
Bosch Sicherheitssysteme GmbH
2
Bolt (X) before breaking out
Bolt (X) fitted, but deactivated
Locking activated
Y
Detector Removal, page 25
X
Operation Guide
Connection | en
3
X
2014.11 | 1.1 | F.01U.283.550
25