Installing Anti-Tip Device - DCS RGU-484GG Installation Instructions Manual

INSTALLING ANTI-TIP DEVICE

All ranges must have an anti-tip device correctly
installed as per the following instructions. If you pull
the range out from the wall for any reason, make sure
that the device is properly engaged when you push
the range back against the wall. If it is not, there is
a risk of the range tipping over and causing injury
if you or a child stand, sit or lean on an open oven
door.
INCLUDED PARTS:
(4) #10 x 2" wood screws, (2) 5/16 x 1 -1/2" sleeve
anchors, (2) lag bolts and washers and
(1) Anti-tip bracket, and (1) Installation Instructions.
INSTALLING THE KIT:
Instructions are provided for wood and cement
floors. Any other type of construction may require
special installation techniques as deemed necessary
to provide adequate fastening of the Anti-tip bracket
to the floor and wall. The use of this bracket does
not preclude tipping of the range when not properly
installed.
WOOD CONSTRUCTION:
Place the bracket against the back wall, into the right
rear corner where the range is to be located. Leave a
gap between the wall (or side of range) and the bracket
(see Fig. 8). Drill (2) 1/8" diameter pilot holes in the
center of the small holes. A nail or awl may be used if a
drill is not available. Fasten the bracket securely to the
floor and wall.
CONCRETE OR CEMENT CONSTRUCTION:
Locate the bracket as described above.
Using the bracket as a template, drill (2x) 5/16"
diameter pilot holes in the centre of the larger holes to
a depth of at least 1- 3/4" . Place the sleeve anchors into
the holes and use a hammer to tap them all the way in.
Tighten the nuts on the sleeve anchors to fasten the
bracket securely to the floor.
For all installations:
Fasten the bracket to the back wall using the two holes
on the top of the bracket. Follow the method described
in 'wood construction'.
ONCE INSTALLED:
Complete the range installation per the instructions
provided with the product. Check for proper installation
of the range and Anti-tip device by grasping the back of
the unit and carefully attempt to tilt the range forward.
(2) Small Holes for Wood
Installations
(2) Large Holes for Concrete
Installations
A
Fig. 8
RGU-48, RDU-48
Model
RGU-36, RDU-36
Series
RGU-30, RDU-30
A 1/2"
A child or adult can tip the range
and be killed.
Install the anti-tip device to the
structure.
Engage the anti-tip device.
Re-engage the anti-tip device if
the range is moved.
See installation instructions for
details.
Failure to do so can result in death or
serious burns to children of adults.
Fig. 9
(2) Wood Screws into Back
Wall (ALL Installations)
BACK
WALL
RGUC-30
5/8"
WARNING!
13
US
CA