Server Driver Installation In Existing Netware 3.12 Server - IBM 16/4 Token-Ring User Manual

8. Shut down your server by entering down and then entering exit from the server
9. Make sure that the diskette you created in step 1 is inserted in drive A. Enter
10. Go to the Novell server directory and enter server at the DOS prompt to
11. Install the patches obtained earlier now. Make sure to select the V3.31 ODI
12. Check for the following conditions to determine whether the adapter is working
If you experience problems, see "Chapter 4. Problem solving" on page 37.
For information concerning NetWare Server error messages, see "Appendix E.
Novell NetWare Server messages" on page 71.

Server driver installation in existing NetWare 3.12 Server

If Novell NetWare is already installed in your computer, perform the following steps
to install the adapter server device driver.
Notes:
a. See "Appendix D. Novell NetWare Server driver parameters" on page 65 for
a complete list of parameters that you can specify on the LOAD IBMTRPO
command in the AUTOEXEC.NCF file.
b. If you experience any problems after loading the Novell NLM files, contact
Novell to ensure that you have the current version of these files.
Press Esc and answer Yes to save the new file to disk. Press Esc again to
return to the server console.
prompt.
the following commands at the server prompt. You might be prompted to
perform a file overwrite; it is OK to overwrite these files.
restart the server.
LAN Updates for Hardware if given the opportunity.
correctly and whether installation has been completed successfully:
v The device driver files are loading successfully. There are no error
messages.
v The adapter LEDs indicate normal operation: Green ON, Amber OFF. See
"Understanding the adapter LEDs and labels" on page 43.
1. Create a diskette containing the extracted files from the NETWAREP.EXE file
on the adapter CD-ROM.
2. Install the patches obtained earlier now. Make sure to select the V3.31 ODI
LAN Updates for Hardware if given the opportunity. Return to the server
console when the installation is complete.
3. Make sure that the diskette you created in step 1 is inserted in drive A. Enter
the following commands at the server prompt. You might be prompted to
perform a file overwrite; it is OK to overwrite these files.
Chapter 3. Software installation
11