Responder Testing On The Network (Optional); Netware 3.11, 3.12, Client 32, Unix, Banyan Vines, And Other Operating Systems - IBM Netfinity 10/100 Ethernet Adapters Installation Manual

v Make sure that you are using the drivers for this adapter (for example,
v If you are replacing an existing adapter, make sure that the LINK statement in
v Verify that the frame type in your NET.CFG file matches your network.
v Test the adapter by running diagnostics in Setup. Additional testing is available
v Check the readme files.

Responder Testing on the Network (Optional)

Setup can test the adapter more thoroughly if there is a responder on the network
while you run the tests.
1. Go to a computer on the network with a comparable PCI adapter installed.
2. Run the appropriate configuration program for the installed adapter and set it up
3. Return to the computer that has the new adapter. Run Setup and test the
NetWare 3.11, 3.12, Client 32, UNIX, Banyan VINES, and Other
Operating Systems
Refer to the online documents. On a DOS computer, view the appropriate readme
file for information on installing your network driver.
To view the readme files, insert the IBM Installation and Drivers CD-ROM or
diskette into a drive, switch to that drive, and enter setup /readme
IBMFEODI.COM).
your NET.CFG is correct for the new adapter. For example, the LINK statement
for a NetWare client is LINK DRIVER IBMFEODI.
by using a responder. See "Responder Testing on the Network (Optional)".
as a responder.
adapter by running diagnostics.
Chapter 2. Configuring Your Adapter
13