Quick Operation Instructions - Concox GPS Vehicle tracker User Manual

to connect the ACC line; otherwise the device will enter ignition detection
status when disconnect the ACC line. If you don't need to anti-theft temporarily,
just connect the ACC line to the positive side in parallel.
3. Tele-cutoff (petrol/ electricity) control line (yellow) is connected to pin 86 of
the Tele-cutoff (petrol/ electricity) relay (equal to the yellow line of the relay
socket).
4. USB cable (3 pin)
Firmware updating interface/expanded function to reserve space.
5. MIC line (2 pin)
Externally connect to microphone for voice monitoring function.
6. SOS line (2 pin)
Externally connect to SOS switch for SOS function.

5. Quick Operation Instructions

Operation Tips: To properly use the device, common parameters should be set
before initial use. This can be done by using the parameter editor or by
sending SMS commands to the device. (","should be English comma and no
space before and after the comma)
5.1 APN setting
To connect default platform http://www.gpsyeah.com, please send the SMS
command below:APN command format: APN,APN's Name#
E.g: APN,internet# ("internet" is the APN of carrier)
The device will reply "OK" if setting successfully.
Note: The APN of some countries have user name and password, you may
need to send SMS command as following:
APN,APN name,user name,password#
E.g: APN,internet,CLIENTE,AMENA#
5.2 DNS setting
To connect other platform, please send the two SMS commands bleow:
Command format：
①APN,APN's Name#
②SERVER,1,DNS,Port,0#
E.g: