Default Patch; Unpatch Patch; Additional Information For Patch; Multiple Channel Patch Matrix - Strand Lighting 200 Console Operation Manual

Default Patch

This will default all patch information back to a one to one status.
Notice the cursor flashing over the 1 for edit patch.
Press the right arrow key to access default patch
then press F3 to Confirm.
Turn on default
Patch?
Yes

Unpatch Patch

This will unpatch all dimmer (output) information.
Notice the cursor flashing over the 4 for unpatch all.
Press F3 to Confirm.
Unpatch the
patch table?
Yes
Note: This will unpatch all dimmers (outputs).
If lights are on at the console, all stage lights will go out.
Note: This can be a very useful way to patch a show.
Start by unpatching all dimmers (outputs), then patch the dimmers to the channels that are needed
for the show.

Additional Information for Patch

Multiple Channel Patch Matrix

A powerful feature of this console is the ability to have any dimmer patched to multiple
channels at once. This allows scenarios like patching a dimmer to a channel to act as a
special. Then patching the same dimmer to a different channel at a proportional level to be
part of a wash.
Page 34
No
No
1. Edit patch
2. Display patch
3. Default patch
Esc
Press F2 for Yes or F3 for No.
4. Unpatch all
Esc
Press F2 for Yes or F3 for No.
Next Confirm
Next Confirm
Strand 200 Console Manual