Recording Submasters - Strand Lighting 200 Console Operation Manual

Recording Submasters

Provide level to any combination of faders (or scenes in submaster mode). Assuming the
patch has not been edited yet, this will bring up each dimmer on a one to one basis with the
fader for the number of faders on your console. (i.e. fader 1 brings up dimmer 1, fader 15
brings up dimmer 15) If this is the 12/24 model, the operator has control of 24 faders. If this
is the 24/48 model, the operator has control of 48 faders.
Press the record button. The LED indicator will start flashing.
(Notice that any flashing amber LED indicates that the fader has already
been loaded with a scene. A new scene can overwrite any previously
recorded scene or effect.)
Press and hold the flash button to the appropriate fader until
it's LED starts flashing.
Press the record button again and all LEDs will go out. This is the console's indication that
the recording process is complete.
Switch to submaster mode and take all channel faders to zero. The
submaster that was just recorded will be indicated by the amber LED that
corresponds to the fader that was just recorded.
Take that fader to full and the lights will go to the recorded level.
Note: After switching to submaster mode with a live fader, the faders hold their levels even though
the mode has been switched. Any fader having any level will hold through a mode change until the
fader is taken to zero.
Note: When switching from submaster mode to any scene mode with a live submaster. It will hold its
levels until the submaster is taken to zero. This will be indicated by the amber LED of the appropriate
submaster flashing.
Page 18 Strand 200 Console Manual