Verification Result Output - Denso AT20B-SM User Manual

7.1.3 Verification result output

(1) Report of match / mismatch status
You can select any of the following report types using the configuration software (ScannerSetting).
Selecting "Disable transmission" reports nothing.
Setting
１
２
３
(2) Beeper and indicator LED
You can check whether the verification result is a match or mismatch with the beeper and indicator LED.
When the beeper and indicator LED are enabled, they act as shown below.
Output of the master data registered
Reading the "Output master data" barcode given below lets the scanner output the verification section of master
data entered in the data verification read procedure, together with the code ID mark.
If there is a match:
Disable transmission.
Enable code data transmission.
Enable OK transmission.
If there is a match:
If there is a mismatch:
"Output master data" barcode
Disable transmission.
Enable code data transmission.
Enable NG transmission.
Beeper
Emits a short beep.
Emits a long beep.
17
If there is a mismatch:
Indicator LED
Lights in blue.
Lights in red.