Connecting The Interface Cable To The Scanner - Denso AT20B-SM User Manual

2.2 Connecting the Interface Cable to the Scanner

(1) Pull the connector cover of the interface cable off its connector as shown below.
(2) Plug the interface cable connector into the connector located in the bottom of the scanner.
Note: As shown below, hold the scanner body, align the
cable connector with that on the scanner, and fully insert the
interface cable connector.
Connector
cover
(3) Align the ▼ mark on the scanner with that on the connector cover, and fully insert the connector cover to the
scanner until the grommet line is shown. Then, turn it clockwise until the boss on the connector cover
becomes horizontal against the scanner.
mark
Connector cover
mark
Interface cable connector
mark
Cutout
Boss
3
mark on the
Scanner
mark
mark
Grommet line
Connector cover
Turn the cover until
its bosses comes to
be horizontal.