Connecting The Interface Cable To The Scanner - Denso AT30Q-SM User Manual

2.2.

Connecting the Interface Cable to the Scanner

(1) Pull the connector cover of the interface cable off its connector as shown below.
(2) Plug the interface cable connector into the connector located in the bottom of the scanner.
Note: As shown below, hold the scanner body, align the ▼ mark on the cable connector with that on the
Note:
scanner, and fully insert the interface cable connector.
Connector cover
(3) Align the ▼ mark on the scanner with that on the connector cover, and fully insert the connector cover to the scanner
until the grommet line is shown. Then, turn it clockwise until the boss on the connector cover becomes horizontal against
the scanner.
▼ mark
Connector cover
Scanner
▼ mark
Connector
▼ mark
Cutout
Scanner
Boss
3
▼ mark
Grommet line
Connector cover
Turn the cover until its
bosses comes to be
horizontal.