Chapter 2 Preparation; Connecting The Interface Cable To The Scanner - Denso GT10B-SM User Manual

Chapter 2 Preparation

2.1

Connecting the Interface Cable to the Scanner

(1) Pull the connector cover of the interface cable off its connector as shown below.
(2) Plug the interface cable connector into the connector located in the bottom of the scanner.
Note: As shown below, hold the scanner body, align the
and fully insert the interface cable connector.
Interface cable connector
Connector cover
(3) Align the two bosses on the connector cover with cutouts in the scanner body, fit the connector cover into the
scanner, and turn it clockwise to lock it.
mark on the cable connector with that on the scanner,
▼
Scanner
mark
▼
Cutout
Boss
Connector cover
2
mark
▼
Connector cover
Turn the cover until the
bosses come to be
horizontal.