System expansions
1
►
Push the rear slot cover plate into the slot (1).
►
Fasten the rear slot cover plate with the screw (2).
►
Reinstall the fan casing if necessary (see "Installing the fan").
►
Close the casing (see "Closing the casing").
If you have installed or removed a PCI board, check the relevant PCI slot settings in the
i
BIOS Setup. If necessary, change the settings. Further information is provided in the PCI
board documentation.
Low-Profile boards
For units with a particularly low overall height, there are so-called low-profile boards with a slot cover
with a lower overall height to match the low-profile units. To also install these low-profile boards in
normal board slots, you must mount a corresponding slot adapter beforehand To do this, you have to
first remove the slot cover from the casing rear panel.
►
Remove the slot cover from the casing rear panel (see "Removing a board") and undo the
screw that holds the slot cover together.
►
Make the required settings for the board.
Do not dispose of the slot cover. If you remove the board again, you must reinstall the slot
!
cover (cooling, fire protection or EMC regulations to be complied with).
36
2
A26361-K1008-Z120-1-7619, edition 1