Charge The Battery; Preparation For Operation; Charging The Battery; Measuring The Initial Value Of Backup Time - Omron POWLI BX35F Instruction Manual

3. Preparation for operation

3-1 Charging the battery

When you connect the AC input plug of this unit to a wall outlet (commercial power), the battery charg-
ing automatically starts regardless of the on/off state of the Power Switch, and it is fully charged within
12 hours.
● This unit has been charged prior to shipment. However, the backup time becomes shorter when using it for
the first time due to spontaneous discharge. We recommend charging this unit before using it.
● If you do not perform the initial backup time measurement described below in "3-2 Measuring the initial
value of backup time", proceed to "4. Operation". → Page 26

3-2 Measuring the initial value of backup time

● When you measure the backup time initial value of the unit in your environment, this value can be used as
a guide when checking the battery and deciding the UPS monitoring software setting values.
"7. Measuring the backup time" → Page 46
See also

3-3 Recharging the battery

The battery is discharged completely when the backup time is measured, so you need to recharge it before
using the UPS.
● You can use connected devices while recharging the battery, but the backup time when a power failure
occurs is shorter until the battery is fully charged.
(If a power failure occurs immediately after the start of charging, backup stops immediately.)
Charge the battery as described in "3-1 Charging the battery."
See also
Preparation for starting operation is now complete.
25
3. Preparation for operation