Maintenance; Programming (Custom); Accessories; Firmware Upgrade - KMC Controls FlexStat Operation Manual

Maintenance

Remove dust as necessary from the holes in the top
and bottom. Clean the display with a soft, damp
cloth and mild soap.
To maintain maximum sensitivity of an optional
built-in motion sensor, occasionally wipe dust or dirt
off the lens—but do not use any fluid on the sensor.

Programming (Custom)

The FlexStat has a library of built-in applications and
options that are configured through the FlexStat's
display. Beyond these standard configurations, cus-
tom changes can be added to a FlexStat using KMC's
BACstage (ver. 2.4.0.26 or later) or TotalControl (ver.
2.0.5 or later). See the FlexStat Application Guide
for more information.
NOTE: Customized programs are the responsibility
of the user. KMC Controls does not provide
support for such programs.
FlexStat

Accessories

See the BAC-12xxxx/13xxxx/14xxxx Series FlexStat
Data Sheet.

Firmware Upgrade

The existing version of firmware can be viewed from
the About the FlexStat screen. (See
Stat on page 6).
Firmware in the FlexStat can be upgraded using a PC
and an HTO-1103 Firmware Flash Upgrade Kit avail-
able from KMC Controls. (For full upgrade instruc-
tions, see the HTO-1103 Installation Guide.) (The old
KMD-5699 part number was changed to HTO-1103
in Aug. 2010 to better reflect its "tool" identity.)
29
About the Flex-
Operation Guide, Rev. R