Table of Contents
Advertisement
Maintenance
Remove dust as necessary from the holes in the top
and bottom. Clean the display with soft, damp cloth
and mild soap.
To maintain maximum sensitivity of optional built-in
motion sensors, occasionally wipe dust or dirt off the
lens—but do not use any fluid on the sensor.
Firmware Upgrade
The existing version of firmware can be viewed from
the About the FlexStat screen. (See
Stat on page
4).
Firmware in the FlexStat can be upgraded using
a PC and a KMD-5699 firmware flash upgrade kit
available from KMC Controls. (For full upgrade
instructions, see the KMD-5699 Installation Guide,
P/N 913-019-04.)
Programming (Custom)
The FlexStat has a library of built-in applications and
options that are configured through the FlexStat's
display. Beyond these standard configurations, cus-
tom changes can be added to a FlexStat using KMC's
BACstage (ver. 2.4.0.26 or later) or TotalControl (ver.
2.0.5 or later). See the BAC-10000 Series Application
Guide (P/N 913-019-03) for more information.
NOTE: Customized programs are the responsibility
of the user. KMC Controls does not provide
support for such programs.
BAC-10000 Series
Accessories
About the Flex-
22
HMO-10000
Horizontal or 4 x
4 handy box wall
mounting plate,
light almond
HMO-10000W
HMO-10000 in
white
HPO-0044
Replacement cover
hex screw
KMD-5567
Network surge
suppressor
KMD-5575
Network repeater/
isolator
KMD-5576
EIA-485 to USB
Communicator
KMD-5624
PC data port
(EIA-485) cable
(FlexStat to USB
Communicator)—
included with the
KMD-5576 (buy for
third-party EIA-
232 interfaces)
KMD-5699
FlexStat firmware
flash upgrade kit
SP-001
Flat blade and hex
end screwdriver
(with KMC logo)
for cover hex
screws
XEE-6111-040
Transformer, 120-
to-24 VAC, 40 VA,
single-hub
XEE-6112-040
Transformer, 120-
to-24 VAC, 40 VA,
dual-hub
Operation Guide, Rev. J
Advertisement
Table of Contents
