Download Print this page

Switching On Your Monitor - IBM ThinkVision L191p User Manual

Ibm user's guide monitor l191p
Hide thumbs

Advertisement

Switching on your Monitor

4.
Connect the DVI connector at the other end of the signal cable to the
DVI port located on the back of the graphics adapter. See picture below.
5.
Connect the power cord to the power port on the back of your monitor if
the power cord supplied is not attached to the monitor. Then insert the
plug into a properly grounded electrical outlet.
6.
Use the cable holder (a) to neatly organize the video and power cables.
7.
Switch on the power source and your computer. To turn on the monitor,
push and release the power switch
the power switch again.
1.
Switch on the power source and your computer.
2.
Switch on your monitor by pushing and releasing the power switch
marked
.
(To switch off your monitor, push and release the power switch again).
3.
To update or install device drivers, follow the instructions in the Device
Driver Installation section found on page 10.
4.
To optimize the displayed image, run Auto Image Setup by following the
instructions in the Auto Image Setup section found on page14.
graphics adapter
DVI
Signal Cable
. To switch it off, push and release
9

Advertisement

loading

  Related Manuals for IBM ThinkVision L191p

This manual is also suitable for:

6135ab1