Windows 95; Auto Image Setup (Analog Only); Auto Image Setup - IBM ThinkVision L191p User Manual

Auto Image Setup (Analog Only)

Auto Image Setup

The Setup Utility
included on the setup
diskette is for displaying dot
patterns. They do not replace or
modify the display driver.
The Auto Image Setup
instructions require the monitor to
be warmed up for 15 minutes.
This is not required for normal
operation.
A I
The
UTO MAGE SETUP
process only applies to the
current screen mode. When a new
mode is selected, repeat this
section to reset the monitor
14
When you first use your monitor you must perform Auto Image Setup. This
procedure sets up your monitor to process the video signals from your
computer without image discoloration or smearing. After you perform Auto
Image Setup, the settings are stored and used each time you turn on the
monitor.
To optimise the displayed image a set-up utility is provided on the CD.
Operation of the utility is dependent on the operating system on your
computer. For correct operation locate the operating system on your
computer from the table below and follow the appropriate instructions. You
can choose to run
A
UTO
This means that if you sometimes use your monitor while running any version
of Windows and sometimes also use it from within DOS (not a DOS window),
you must run
A I
UTO MAGE
versions of
A I
UTO MAGE
Operating System
DOS
Windows 3.1, Windows 95,
Windows 98, Windows 2000,
®
Microsoft Windows NT ,
Windows Me or Windows XP
Before you begin
A
UTO
1. Make sure the computer's video mode is set in the range of the
supported screen resolution shown in the Table on page 26.
You should perform
A
for each operating system that you use.
I S
MAGE ETUP
for both Windows and DOS. You can run
S
ETUP
in any order.
S
ETUP
Corresponding Auto Image Setup procedure
Auto Image Setup for DOS on page 15
Auto Image Setup for Windows 3.1, Windows
95, Windows 98, Windows NT, Windows 2000,
Windows Me or Windows XP
for your computer:
I S
MAGE ETUP
for each screen mode you use.
I S
UTO MAGE ETUP