General Operating Information - Quadra-Fire MTVERNINSAE-MBK Owner's Manual

MT. VERNON AE INSERT
Size
• Pellets are either 1/4 inch or 5/16 inch (6-8mm) in diameter
• Length should be no more that 1-1/2 inches (38mm)
• Pellet lengths can vary from lot to lot from the same
manufacturer
• Due to length variations, the fl ame height (feed rate) may
need adjusting occasionally. See page 9 for instructions.
Performance
• Higher ash content requires the ash drawer to be emptied
more frequently
• Hardwoods require more air to burn properly
• Set wall control to "Utility Pellet" if the fi repot and ash pan
are fi lling quickly. This will cause the auto-clean system
to empty the fi repot more often.
• Premium wood pellets produce the highest heat output.
• Burning pellets longer than 1-1/2 inches (38mm) can cause
an inconsistent fuel feed rate and/or missed ignitions.
We recommend that you buy fuel in multi-ton lots whenever
possible. However, we do recommend trying various brands
before purchasing multi-ton lots to ensure your satisfaction.
Changing to Different Fuel Type
• Empty the hopper of the previous fuel
• Thoroughly vacuum hopper before fi lling with the new fuel
• Select the appropriate setting on the FUEL SELECTION
screen on the thermostat wall control
The burn rate, BTU content and heat output will all vary
depending on the fuel selected.
Storage
• Wood pellets should be left in their original sealed bag until
using to prevent moisture absorption.
• Shelled corn, wheat or sunfl ower seeds should be stored in
a tight container to prevent it from absorbing moisture from
damp or wet fl oors.
• This will also prevent rodents from becoming a problem.
• Do not store any pellet fuel within the clearance requirements
or in an area that would hinder routine cleaning and
maintenance.
CAUTION
Tested and approved for wood pellets, shelled fi eld corn,
wheat and black oil sunfl ower seeds. Burning of any other
type of fuel voids your warranty.
8
E. General Operating Information
Read and understand the Thermostat Wall Control
manual for detailed operating instructions. The wall con-
trol is an integral part of how to operate this appliance.
1. Thermostat Wall Control - Automatic Setting
The appliance is like most modern furnaces; when the
thermostat wall control calls for heat, your appliance will
automatically light and deliver heat.
When the room is up to temperature and the wall control is
satisfi ed the appliance will shut down.
In the automatic setting the heat output level is controlled by
the wall control. Select "Automatic" on the AUTO/MANUAL
screen. Figure 8.1.
Figure 8.1
2. Thermostat Wall Control - Manual Setting
When you select "Manual" on the AUTO/MANUAL screen the
appliance will still automatically turn on and off according to
the temperature setting.
However, you will be able to manually control the heat output
levels. Adjust the heat output levels by using the HEAT
OUTPUT LEVEL screen. Figure 8.2.
Figure 8.2
3. Auto-Clean Firepot System
Your appliance is equipped with an automatic fi repot cleaning
system that will change the frequency of cleaning based on
the fuel being burned.
The auto-clean system will clean itself immediately on initial
plug in. If there is a power outage, as soon as power is
restored it will recycle and clean itself if there is no fi re in the
fi repot.
NOTE: User is responsible for removing the ash from the
ash drawer.
Hot while in operation. Keep children, clothing and furniture
away. Contact may cause skin burns.
7036-187C
AUTO/MANUAL SETTINGS
Automatic
Manual
Off
Medium
CAUTION
June 18, 2014