Trimming Outboard Motor; Adjusting Trim Angle (Power Trim And Tilt) - Yamaha F350 Owner's Manual

TIP:
The engine can also be stopped by pulling
the engine shut-off cord and removing the
clip from the engine shut-off switch, then
turning the main switch on the main station to
" " (off).
2. Remove the key if the boat will be left un-
attended.
EMU27862

Trimming outboard motor

EWM00740
WARNING
Excessive trim for the operating condi-
tions (either trim up or trim down) can
cause boat instability and can make
steering the boat more difficult. This in-
creases the possibility of an accident. If
the boat begins to feel unstable or is hard
to steer, slow down and/or readjust the
trim angle.
The trim angle of the outboard motor helps
determine the position of the bow of the boat
in the water. Correct trim angle will help im-
prove performance and fuel economy while
reducing strain on the engine. Correct trim
angle depends upon the combination of
boat, engine, and propeller. Correct trim is
also affected by variables such as the load in
the boat, sea conditions, and running speed.
ZMU07298
1. Trim operating angle
EMU27888
Adjusting trim angle (Power trim and
tilt)
EWM00753
WARNING
Be sure all people are clear of the out-

board motor when adjusting the trim
angle. Body parts can be crushed be-
tween the motor and the clamp bracket
when the motor is trimmed or tilted.
Use caution when trying a trim position

for the first time. Increase speed gradu-
ally and watch for any signs of instabil-
ity or control problems. Improper trim
angle can cause loss of control.
If equipped with a power trim and tilt

switch located on the bottom cowling,
use the switch only when the boat is at
a complete stop with the engine off. Do
not adjust the trim angle with this
switch while the boat is moving.
Adjust the outboard motor trim angle using
the power trim and tilt switch.
Operation
91