Station Selector Switch; Engine Selector Switch; Engine Shut-Off Cord (Lanyard) And Clip - Yamaha F350 Owner's Manual

Components
Quad type
When constant speed is desired, tighten the
adjuster to maintain the desired throttle set-
ting.
EMU35711

Station selector switch

The station selector switch can select either
the main station or sub station for the digital
electronic control which operates the boat.
The digital electronic controls of the main
station and sub station have the same func-
tions. You can change the station when the
main switch is turned to "
trol levers are in Neutral.
The switch panel can be operated at both the
main station and sub station when the main
switch is set to "
EMU35720

Engine selector switch

When all engines have started, you can se-
lect the desired engine for operation by
pushing the engine selector switch. The en-
38
ZMU07295
" (on) and all con-
" (on).
ZMU07141
gine selector switch works only when all the
control levers are in neutral.
1. Engine selector switch
EMU35774
Engine shut-off cord (lanyard) and
clip
The clip must be attached to the engine shut-
off switch for the engine to run. The cord
should be attached to a secure place on the
operator's clothing, or arm or leg. Should the
operator fall overboard or leave the helm, the
cord will pull out the clip, stopping ignition to
the engine. This will prevent the boat from
running away under power.
EWM01790
WARNING
Attach the engine shut-off cord to a se-

cure place on your clothing, or your
arm or leg while operating.
Do not attach the cord to clothing that

could tear loose. Do not route the cord
where it could become entangled, pre-
venting it from functioning.
Avoid accidentally pulling the cord dur-

ing normal operation. Loss of engine
power means the loss of most steering
control. Also, without engine power,
the boat could slow rapidly. This could
cause people and objects in the boat to
be thrown forward.
1
ZMU05977