Yamaha F350 Owner's Manual page 119

ation and be lost.
1. Apply Yamaha marine grease or a corro-
sion resistant grease to the propeller
shaft.
2. Install the thrust washer and propeller on
the propeller shaft. NOTICE: Make sure
to install the thrust washer before in-
stalling the propeller. Otherwise, the
lower case and propeller boss could
be damaged.
3. If there is a pin on the damper, align with
the hole in the spacer. Install the spacer
and washer. Tighten the propeller nut to
the specified torque.
1. Cotter pin
2. Propeller nut
3. Washer
4. Spacer
5. Propeller
6. Thrust washer
[ECM01881]
6
5
4 3
ZMU07187
1. Hole
2. Pin
Propeller nut tightening torque:
54 Nm (5.51 kgf-m, 39.8 ft-lb)
4. Align the propeller nut with the propeller
shaft hole. Insert a new cotter pin in the
hole and bend the cotter pin ends.
2
NOTICE: Do not reuse the cotter pin.
Otherwise, the propeller can come off
during operation.
1
TIP:
If the propeller nut does not align with the
propeller shaft hole after tightening to the
specified torque, tighten the nut further to
align it with the hole.
Maintenance
1 2
[ECM01891]
ZMU07328
113