Empire Comfort Systems DVX36FP32CLN-2 Installation Instructions And Owner's Manual page 42

Direct vent zero clearance gas fireplace heater
Table of Contents

Advertisement

15. Place Front Center Log (L) between third and fourth grates on
the burner. The short "Y" branch will point left and the bottom
of the "Y" resting on the firebox bottom.
16. Place Front Right Log (M) on the fifth grate from the left with
the top resting on (K) Log.
ATTENTION: Do not place decorative rock on logs or on burner.
The decorative rock should only be placed on the fireplace
floor.
17. After all logs are properly positioned, place small "dime" size
pieces of Rockwool lightly across the front round "blueflame"
ports. Place the ember material (Rockwool pieces) side by side.
Do not stack more than one layer of embers across the burner
ports. See Figure 63.
Page 42
LOG PLACEMENT (13 LOG SET)
Figure 63
18. Replace glass door onto firebox.
19. Secure the two glass frame spring clamps at bottom of
firebox.
20. Align the tabs on top louver brackets with slots in front posts to
secure top louver.
21. Close bottom louver. Lift slightly to engage the end tabs into
the slots in fireplace sides to close louver panel.
WARNING: Failure to position the parts in accordance
with this diagram or failure to use only parts specifically
approved with this appliance may result in property
damage or personal injury.
Attention: Refer to Log Identification Page 39, and Figures 65
and 66 to order logs.
Caution: If a log is broken, cracked or chipped, order a
replacement log. See page 43.
Figure 64
30329-0-0312

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents