Trango Systems TrangoLINK-45 User Manual page 50

Trango Systems, Inc
Autoscan MU
RSSI LED
Active Channel/Polarization: The current channel and polarization of the radio when Opmode is \"On\".
Speed:
Power:
Range:
Remarks:
MIR:
ARQ: .
Encrypt: .
Key: .
Activate Opmode On:
Activate Opmode Off:
Reboot:
Close All Telnet Sessions:
LT‐9037A
(RU Only). If this switch is enabled, when not connected to MU, the RU will
automatically automatically scan all available channels and frequencies
Enables and disables RSSI LEDs. Disabling the LEDs provides slight improvement to
radio performance. Typically RSSI LEDs should be enabled during alignment and
disabled during normal operation.
Transmit over‐the‐air raw data rate.
Transmit RF power setting.
Allowable range of the transmit power based on the current settings of the
active channel and the speed.
A descriptive text field for general use (i.e. the location of the unit). It does not
affect system performance.
Set Maximum Information Rate for network traffic.
Auto Retransmit Request. When enabled, dropped packets are detected at the
receiver and retransmitted by the transmitter.
Encryption. Enables and disables proprietary 128 bit over‐the‐air encryption.
1 28 Encryption Key. Must match in both MU and RU.
Activates radio's Opmode to "On"‐transmitting.
Activates radio's Opmode to "Off" not‐transmitting.
Reboot the unit.
Close all the active telnet sessions.
August 15, 2011
TL45 User Manual Rev 2.0r3
Page 49