Trango Systems, Inc
You will be greeted with current hardware and firmware information and prompted for a password. Type in the password
and press enter. The factory default read/write password is trango.
Welcome to Trango Broadband Wireless, TrangoLINK-45 DFS PtP-P5055M 2p0r3D09091501
Password:
Login as read/write.
Check the VLAN status
#>vlan
[current] No VLAN
[config] No VLAN
Success.
Enable VLAN management with VID 2 with class of service queueing enabled
#>vlan 2 cos
Success.
Enable VLAN management with VID 2 with class of service queueing disabled
#>vlan 2 nocos
Success.
Note: cos and nocos will be chose upon customer needs. If cos is enabled, packets with a higher priority tag (COS field in
the VLAN tag) will be forwarded first through the radio in the event that an overloading/burst condition occurs at the
Ethernet port or the rate shifting reduces the available throughput at the RF link below the level coming into the Ethernet
port. The queuing method is strict with priority 7 being the highest and priority 0 being the lowest.
It is recommended to give the management VLAN the highest priority (7) to ensure communication with the radio in a
heavy traffic situation.
vlan
vlan none
vlan <id,2..4095> cos
vlan <id,2..4095> nocos
Note: Type help for a listing of all CLI commands. Type help [<command>], for the syntax of a particular command.
Note: If you cannot access the radio management functions via the Ethernet port, check all cable connections and ensure
that your PC is set up with a properly routable subnet.
LT‐9037A
Useful Commands to configure management VLAN on Trangolink45:
August 15, 2011
show current status
Disable vlan
enable and assign vlan tag with cos
enable and assign vlan tag without cos
TL45 User Manual Rev 2.0r3
Page 16