Engine Oil Change (4 Stroke) - KYMCO Vitality 50 Owner's Manual

ENGINE OIL CHANGE (4-STOKE)
1. Place the scooter on its centre stand on level ground.
2. Remove the oil filter cap/dipstick (1).
3. Remove the drain bolt (2) to drain the oil.
4. Install the drain bolt and tighten it. (Torque: 30 Nm)
5. Refill 0.7 litres of fresh engine oil. Firmly tighten the oil dispstick.
6. Warm up the engine and check the oil level again after is stopped
for 30 – 40 seconds.
• Specified oil: SAE10W40
• Capacity / Refilling Capacity: 0.85L / 0.7L
• When changing the engine oil, also clean the oil strainer
and reinstall it.
• Use the specified engine oil.
• Change the engine oil after the first 300km and th
it at every 2000km.
• Engine oil will deteriorate easily and require mo
frequent change if the scooter is ridden often in dusty
or cold climates or if it is ridden only for short distances.
• Do not mix engine oil of different classes or viscosities. It
may cause damage to the engine.
- 50 -
en c hang e
re
areas