Brick Set Installation; Brick Clip Installation - Quadra-Fire CB1200MI-MBK Owner's Manual

CB1200-I Pellet Insert
G. Optional Brick Set Installation
1. Slide bottom of left rear brick in fi rst; rotate top edge to-
ward rear of appliance and then rotate outer edge toward
rear of appliance, until brick slides into place. Figure
24.1. Repeat for right rear brick.
2. Place left side brick along left side of fi rebox, making sure
chamfered (beveled) back edge fi ts snugly next to left rear
brick. Figure 24.2. Repeat with right side brick.
3. Complete brick set, correctly installed. Figure 24.4.
Figure 24.1
3
Figure 24.2
3
1
Figure 24.3
Page 24
1
1
2
4
2
Risk of Injury.
• Brick may have small wires protruding from
the back of brick.
H. Brick Clip Installation
1. After the brick set has been installed, 2 brick clips need to
be installed on the outer edge of baffl e to keep the brick
set in place. Remove the baffl es from the appliance before
installing the brick clips.
2. Using pliers, bend the brick clip slightly past 90° in the
direction shown in Figure 24.4.
3. Position the brick clip as shown in Figure 24.4 and use pliers
to crimp around the outside edge of the baffl e. Figure 24.5
shows the fi nished shape of the brick clip after being bent
around the outside edge of the baffl e.
4. Slide the baffl es back into place making sure that the brick
clip holds the brick out toward the wall of the fi rebox. Push
back on the sides so they keep the rear bricks in place.
Repeat for the opposite side.
Top outside
corner of Baffle
Figure 24.4
Installed Clip
Figure 24.5
7014-188
WARNING
Approximately
1 inch
Brick Clip
September 16, 2009
R
Outside edge
of Baffle