Removing The Negative Ion Generator - Sanyo SAP-KRV94EHDX Technical & Service Manual

(2) Secure the drain pan to the hook.
(2-1) Push up A and B in the figure one by one
from underneath to secure them to the hook.
(2-2) Also secure C to the hook.

8-6. Removing the Negative Ion Generator

Remove the negative ion electrodes and negative ion
P.C.Board from the drain pan (Air Outlet Ass'y).
Negative ion electrodes
Drain pan (Air Outlet Ass'y)
Negative ion electrodes
Negative ion P.C.Board
Negative ion P.C.Board
Cables cannot removed unless
this part is removed.
35
C.
B.
Bottom of left
back of the drain pan
Remove the lead
wire connector.
Scope of service supply
Negative ion electrodes
The negative ion generator is supplied
NOTE
with a set of negative ion electrodes and
negative ion P.C.Board.
A.
Bottom of right
back of the
drain pan
This connector was
disconnected from
the P.C. Board of the
electrical component
box.
Remove the ring
connector.