Disassembly Procedures; Removing Front Grille - Sanyo SA–93AH Technical & Service Manual

9. DISASSEMBLY PROCEDURES

Model SA– 93AH
NOTE
These illustrations are based on typical view of a standard
model. Consequently, the shape may differ from that of the
air conditioner which you are servicing.

9-1. Removing Front Grille

(1) Open the air intake.
(2) Remove the screw holding the grille in place. (Fig. 1)
(3) Slide the side of the grille to the left and right to
disengage the tabs on the left and right sides of the
grille from the slots.
(4) Pull the bottom portion of the grille toward you while
paying attention to the ventilator lever. (Fig. 2 and 4)
NOTE
Pulling out too far on the bottom of the grille at this point
could damage the tabs at the top. Do not pull the grille out
more than 100 mm.
(5) After confirming that the ventilator lever has been
disengaged from the grille vent, slide the grille upward to
free the two tabs at the top of the grille from the
rectangular holes in the top of the cabinet. (Fig. 3 and 4)
Air
deflection
grille
Ventilator lever
Grille
Tab
Grille
Fig. 4
19
Pull out 70mm –
100mm
Slot
Tab
Slot
Fig. 1
Cabinet
Fig. 2
Cabinet
Fig. 3