Ir Parameter Configuration; Display Settings - HIKVISION IR Speed Dome User Manual

User Manual of IR Speed Dome


Display Settings

Purpose:
You can enable or disable the on-screen display of PTZ movements, alarms, time, presets, zone,
address, error rate, and fan/heat show, etc.
Steps:
(1) Move the cursor to DISPLAY SETTINGS using the direction buttons and click IRIS+ to enter.
(2) Move the cursor to the target item and click IRIS+ and click up/down direction buttons to
choose each display mode as ON or OFF, and define each display time as 2 seconds, 5 seconds
or 10 seconds.
(3) Click IRIS+ button to confirm the settings.
Note: If you enable the OSD for both ZOOM and PT, while calling a preset, the preset No. will be
displayed on the screen till the preset scene passes.
The speed dome shows the viewing direction when you manually control it to rotate.
Display N
Indication North Northeast
Note: The north direction refers to the zero angle (initial position).


IR Parameter Configuration

Purpose:
You can configure the IR parameters including the IR sensitivity, n/m LED current, reference height,
reference zoom, and LED control, fan control, switch delay, heat control, and IR correction, etc.
Enter the LED parameter submenu:
MAIN MENU > DOME SETTINGS > SYS INFO SETTINGS > IR PARAMETER
© Hikvision Digital Technology Co., Ltd. All Rights Reserved.
DISPLAY SETTINGS
ZOOM SHOW
PT SHOW
TIME SHOW ON
PRESET SHOW ON
ZONE SHOW ON
ADDRESS SHOW ON
ERROR RATE SHOW
BACK EXIT
Figure 3-6 Display Settings
Viewing Direction Display
Table 1-2
NE E
East
DISPLAY SETTINGS
2 FAN AND HEAT SHOW
2
ON
BACK
SE S
Southeast South
OFF
EXIT
SW W
Southwest West
16
NW
Northwest