Chapter 3 Parameter Configuration; Network Camera Configuration; Wireless Network Camera(Only Support -W Series) - HIKVISION 2DC Series User Manual

There are several network parameters of the camera that need to be set after the hardware installation.
Those parameters including IP address, subnet mask and port number, etc. can be set through various
kinds of methods, 2 of which are introduced as below.
1. Set the camera parameters such as IP address and PPPOE through IE.
2. Set the camera parameters through the client software.
Please make sure that the PC and network camera are connected and can ping successfully before the
parameter setting.

3.1 Network Camera Configuration

3.1.1 Wireless Network Camera(Only support –W series)
Type 1: Point to Point Connection Mode
In the mode, IP camera directly links to the wireless network laptop. It's shown as following figure:
[Notice] The above-mentioned function is reserved at present.
Chapter 3 Parameter Configuration
11