Relay Satellite Key Switch Interface Wire Connection Guide - Directed Electronics Python 450 ESP Installation Manual

H1/12 RED/WHITE Channel 2, (-) 200 mA output
When the system receives the code controlling Channel 2, for longer than 1.5 seconds, the RED/WHITE wire will
supply an output as long as the transmission continues. This is often used to operate a trunk/hatch release or
other relay-driven function. This output can also be programmed to provide the following types of output: Instant
validity, latched, latched-reset with ignition, 30-second timed, or second unlock output. (See Features Description
section of this guide for details.)
IMPORTANT! Never use this wire to drive anything except a relay or low-current input! The transis-
torized output can only supply 200 mA of current. Connecting directly to a solenoid, motor, or other
high-current device will cause it to fail.
relay satellite key switch interface wire
connection guide
All except the red heavy gauge wires leading from the relay satellite are used to energize high current circuits
in the vehicle. It is crucial that these connections are made correctly so that they are capable of handling the
current demands. For this reason, scotch locks, T-taps and other such connectors should not be used.
RED (2) (+)12V input for relays
Remove the two 30 amp fuses prior to connecting these wires and do not replace them until the satellite has
been plugged into the control module. These wires are the source of current for all the circuits the relay satel-
lite will energize. They must be connected to a high current source. Since the factory supplies (+) 12V to the key
switch that is used to operate the motor, it is recommended that these wires be connected there.
NOTE: If the factory supplies two separate (+) 12V feeds to the ignition switch, connect one RED
wire of the satellite to each feed at the switch.
12
© 2000 Directed Electronics, Inc. Vista, CA