Remote Start Safety Features; Entering The Vehicle While It Is Running Via Remote Start; Pre-Heating Or Pre-Cooling The Interior Of The Vehicle; Using The "Quick-Stop" Feature - Code Alarm F60 Owner's Manual

Using Your Remote Starter (cont'd)
Remote Start Safety Features
For safety and security reasons, the F60lF65 will shut off the vehicle
during remote start if any of the following occur:
• The vehicle hood is opened
• The brake is pressed before the vehicle ignition is turned on
with the key
• The engine reaches 3 times its normal idle'
• The alarm is triggered
As a safety precaution, the vehicle will shut off if left unattended for 12
or 25 minutes, depending on the time preset by your installer.
Entering the Vehicle While It
is
Running via Remote Start
1. Press DISARM to unlock the door(s) and turn off the alarm
system (if it is not already off).
2. Enter the vehicle. Do not press the brake pedal.
3. Insert the key into the ignition and turn to the ON position.
4. Press the brake pedal. The remote starter disengages and the
vehicle will operate normally.
Pre-Heating or Pre-Cooling the Interior of the Vehicle
Before exiting the vehicle, set the temperature controls to the desired
setting and operation. After the
F601F6~
starts the vehicle, the heater
or air-conditioning will activate and heat or cool the interior to your
setting.
Using the "Quick-stop" Feature
If you want to make a short stop and leave your vehicle running (to keep
the interior warm or cool, for instance), the quick stop feature allows
you to do this while keeping your vehicle secure and your keys with you.
To
engage quick
stop:
1. While vehicle is running, place the transmission in PARK.
2. With your foot off the brake pedal, press and hold the START
button on the remote control. The parking lights will turn on,
indicating that the vehicle is now running via remote start.
3. Remove the keys from the ignition and exit the vehicle. Press
ARM to arm the alarm system if desired.
Nole: Do not leave children or animals unattended in the vehicle
when using the quick stop feature .
• The tach wire must be connected and the system must be in tach monitor mode.
101101·4 F6()"65.p65 7 9113101,12:14 PM
7