Code Alarm F60 Owner's Manual page 9

~~~~~M~a~in~t~e~n~a~n~c;e~~~~~~~~~~~~~'9
Changing the Remote Control Battery
The 12-volt alkaline battery supplied in your remote
transmitter should last approximately one year,
depending on usage. When the battery begins to
weaken, you will notice a decrease in range, or
the distance from your vehicle that your remote
transmitter will operate. Follow the instructions
below to change the remote transmitter battery.
Open Back of
Remote TlP,:psmitter
1. Using a coin pry off the back of the transmitter Itne
transmitter snaps together} and expose the battery.
2. Remove the old battery and replace with GP-23A or
equivalent. Be sure to observe the (+) and (-) signs in the battery
compartment.
3. Replace the case backing, then test the remote transmitter.
It is not necessary to re-program the remote transmitter after
changing the battery.
Adding Remote Controls to Your System
The F60/F65 has the ability to operate from up to eight (S) remote
controls. Follow these instructions to add a remote control to your
system.
1. Make sure the system is disarmed and the ignition is off.
2. Open the driver'S door.
3. Turn vehicle ignition on.
4. Press and hold emergency override button.
After 15 seconds, the horn will sound three (3) times. This
indicates that the unit has entered the remote control
programming mode.
5. Release the button.
6. Press the ARM button (button 1) on the remote control to be
programmed.
The horn will sound once, indicating that the system has
"learned" that remote control.
7. Repeat step 6 for any additional remote controls.
S. Turn the vehicle ignition off to exit the programming mode.
Test all remote controls to ensure that they work properly.
101101-4 F6Q-65.p65 9
9113101,12:14 PM