Remote Start Safety Features; Entering The Vehicle While It Is Running Via Remote Start; Pre-Heating Or Pre-Cooling The Interior Of The Vehicle; Turning On The Rear-Window Defroster - Code Alarm PC 7600 Owner's Manual

Using Your Remote Starter

Remote Start Safety Features

For safety and security reasons, the Power Code PC 7600
off the vehicle during remote start if any of the following occur:
• The vehicle hood is opened
• The brake is pressed before the vehicle ignition is turned on
with the key
• The engine reaches 3 times its normal idle
• The alarm is triggered
As a safety precaution, the vehicle will shut off if left unattended for 15
or 24 minutes, depending on the time preset by your installer.

Entering the Vehicle While It is Running via Remote Start

1. Press DISARM to unlock the door(s) and turn off the alarm
system (if it is not already off).
2. Enter the vehicle. Do not press the brake pedal.
3. Insert the key into the ignition and turn to the ON position.
4. Press the brake pedal. The remote starter disengages and the
vehicle will operate normally.

Pre-Heating or Pre-Cooling the Interior of the Vehicle

Before exiting the vehicle, set the temperature controls to the desired
setting and operation. After the Power Code
heater or air-conditioning will activate and heat or cool the interior to
your setting.
Turning on the Rear-Window Defroster (if connected)
While the vehicle is running via remote start, press DEFRST on the
remote control. The vehicle defroster will activate and run for 10
minutes, or for your vehicle's preset time limit.

Using the "Quick-stop" Feature

If you want to make a short stop and leave your vehicle running (to keep
the interior warm or cool, for instance), the quick stop feature allows
you to do this while keeping your vehicle secure and your keys with you.
To engage quick stop:
1. Stop the vehicle and place the transmission in PARK.
2. With your foot off the brake pedal, press the ARM button, then
press the START button on the remote control within 2 seconds
The parking lights will turn on, indicating that the vehicle is now
running via remote start.
3. Remove the keys from the ignition and exit the vehicle. Press
ARM to arm the alarm system if desired.
Note: Do not leave children or animals unattended in the vehicle
when using the quick stop feature.
(cont'd)
TM
starts the vehicle, the
7
TM
will shut