REMEHA Avanta Plus 28c User Manual page 10

R
3x
LT.NL.W6H.000.073 LTNLW6H000073A
R
4x
LT.NL.W6H.000.074
LTNLW6H000074A
Remeha Avanta Plus

In the comfort mode the boiler will be seen to run
occasionally even if time clocks are in the off position.
0 = Comfort mode
1 = Eco mode
2 = regulated by controller (= factory setting)
Change the mode as follows:
• Press 'Enter'- key until codes p [ and [ 1 are dis-
played alternately.
• Press [+]- key 3x until codes p [ and [ 4 are dis-
played alternately.
• Press 'Enter'- key; setting of 'eco or heat retention' mode
is displayed (mode 2 = heat retention and regulator-
dependent, factory setting).
• Press [-]- key to change this mode, for example mode 1
(=eco mode).
• Press 'Enter'- key to confirm this mode; codes p [ and
[ 4 are displayed alternately.
• Press 'Reset'- key to switch boiler to operating mode.
Changing P5 setting: (no) anticipated current

Boiler responds to temperature changes after a certain time,
input via on/off thermostat. Response time can be reduced by
enabling 'Anticipated current' option (only when the on/off ther-
mostat has an anticipation current setting device). When the
boiler is installed this setting has been already been adjusted.
Ask your service engineer for further details.
Change the anticipated current (if necessary) setting as fol-
lows:
• Press 'Enter'- key for 1 second until codes p [ and [
1 are displayed alternately.
Press [+]- key 4x until codes p [ and [ 5 are dis-
•
played alternately.
• Press 'Enter'- key; (no) anticipated current setting is dis-
played (mode 0 = no anticipated current, factory setting).
• Press [-]- key to change this mode, for example mode 1
(=anticipated current).
• Press 'Enter'- key to confirm this mode; codes p [ and
[ 5 are displayed alternately.
• Press 'Reset'- key to switch boiler to operating mode.
10