Positioning The Cooker; Moving The Cooker - Rangemaster Professional+ 100 FX User's Manual & Installation Instructions

Check the appliance is electrically safe and gas sound when you have nished.

Positioning the Cooker

Fig.7-1 shows the minimum recommended distance from the
cooker to nearby surfaces.
The cooker should not be placed on a base.
Above hotplate surround should be level with, or above, any
adjacent work surface.
A gap of 75 mm should be left between each side of the
cooker ABOVE the hotplate level and any adjacent vertical
surface.
For non-combustible surfaces (such as unpainted metal or
ceramic tiles), this can be reduced to 25 mm.
A minimum space of 650 mm is required between the top of
the hotplate and a horizontal combustible surface.
Fig.7-2 shows the suggested clearances above the cooker.
*Any cookerhood should be installed in accordance with the
hood manufacturer's instructions.
**Any splashback must be tted in accordance with the
manufacturers instructions. Allowance should be made for the
ue trim, which is tted to the cooker hob.
Surfaces of furniture and walls at the sides and rear of the
appliance should be heat, splash and steam resistant. Certain
types of vinyl or laminate kitchen furniture are particularly
prone to heat damage and discolouration.
We cannot accept responsibility for damage caused by
normal use of the cooker to any material that de-laminates
or discolours at temperatures less than 65 °C above room
temperature.
We recommend a gap of 1000 mm between units to allow
for moving the cooker. Do not box the cooker in – it must
be possible to move the cooker in and out for cleaning and
servicing.

Moving the Cooker

On no account try and move the cooker while it is
n n
plugged into the electricity supply.
The cooker is very heavy, so take great care.
n n
We recommend that two people manoeuvre the cooker.
Make sure that the oor covering is rmly xed, or removed,
to prevent it being disturbed when moving the cooker
around.
To help you, there are two levelling rollers at the back, and
two screw-down levelling feet at the front.
Remove the polystyrene base pack. From the front, tilt the
cooker forward and remove the front half of the polystyrene
base (Fig.7-3). Repeat from the back and remove the rear half
of the polystyrene base.
INSTALLATION
410 mm min
ArtNo.105-0009-100DF-2BC Min distances above cooker
21
75 mm 75 mm
min min
650 mm
min
Professional
+ 100 FX
1000 mm min*
**
Professional + 100 FX
Fig.7-1
905 mm min
930 mm max
Fig.7-2
Fig.7-3