Advertisement
english
deutsch
francais
español
factory reset
Factory reset erases all memorised source and system
settings, and sets all back to default values .
service
Service enters the service menu . This is available to
authorised service personnel only . Entering the service menu
without proper knowledge may permanentely damage the
projector .
remote control ID
The projector can be set up to have a unique ID, so that
it only responds to remote controls transmitting the same
ID . Up to 99 units can be handled without interfering with
eachother, using the same remote . By default, the projector
is set to respond to any one remote control, thus is set to
"broadcast" . To change, and set a unique ID, select, and
change the value with the left / right arrow keys .
To set the remote control to broadcast to a specific ID, press
the asterisk key ("*"), and enter a number that corresponds
with the projector you wish to control using the numeric
keypad . When pressing the asterisk key towards a projector,
it will respond with its unique ID, and prompt the user to
enter a matching one .
DPMS
Enable or disable the DPMS (Display Power Management
Signalling) . When enabled, the projector will automatically
switch to standby mode after a specified time if there is no
valid source present at its inputs . When a valid source is
reconnected, the projector will start up again .
DPMS timeout
DPMS can be set from 1 – 180 minutes . Default is 30
minutes .
backlight timeout
Set the amount of time before the backlight for the on-board
keypad fades out after use . Default is 30 seconds .
menu timeout
Set the amount of time before the menu automatically goes
away if not used . Default is 30 seconds .
splash
Select the splash screen to be displayed if no valid source is
connected . Options include black, grey, and white .
baudrate
Set the baudrate at which the projector communicates over
RS232 . Options include 4800, 9600, and 19200 bps . See
separate documentation for details on RS232 and LAN
communications .
DS+305/DS+305 User Manual
62
020-000057-01 Rev. 1 (06/08)
Advertisement
