SunStar SPS/ D-B1254 Series User Manual page 32

C. Setting the trimming shaft in place
Unfasten the trimming drive link screw and the
trimming shaft collar screw.
Make the trimming shaft tip accord with part
arm.
Tighten the screws.
D. Settion up the link stopper position
Unfasten the joint screw of the thread trimmer drive
link stopper in a status the thread trimmer is not
operated. And then adjust to correct the notch
intervals between the thread driving link and the
thread driving link stopper to be 0.3mm each.
And fasten the joint screw .
E Setting the thread trimming solenoid in place
After unfastening the thread trimming solenoid bracket screw, have the trimming shaft and the thread trimming
solenoid rotary link 0.5mm apart from each other and tighten the screw back on.
Unfasten the thread trimming solenoid rotary link screw and drive the thread trimming solenoid rotary link
manually to move the trimming shaft collar 6.8mm in the direction of the arrow.Then, tighten the screw back on.
Check if the trimming shaft collar retums to its place when the thread trimming solenoid rotary link returns.
32
of the
Screw
Thread Trimming
Rotation Link
Thread
Trimmer Cam
Screw
Thread Trimming
Driving Link
0.3mm
Thread
Trimmer
Driving
Link
0.3mm
Thread Trimmer Solenoid Bracket
Solenoid
Screw
0.5mm
6.8mm
Thread Trimmer Shaft
Thread
Timmer Shaft
Collar for Thread
Trimmer Shaft
[ Fig. 51 ]
Screw
Thread Trimmer
Driving Link Stopper
[ Fig. 52 ]
Thread Trimming
Rotation Link
[ Fig. 53 ]