Table of Contents
Advertisement
Message Intersect & Pack
Message Intersect
1D, Program Intersect Option
A command input consists of 3 decimals. The first input is for barcode format; Refer to "Symbologies ID
Number". The second input is for intersecting direction; "000" denotes ascending (left to right) and "001"
denotes descending. The following 2 inputs are for start digital and end digital.
For example, intersect EAN-13 from 1st digit to 3rd ascending and from reciprocal 4th to reciprocal 1st.
1. Read "Code Programming ON"
2. Read "Allow Intersection"
3. Read "Add Intersect Option"
4. Check Symbologies ID Number table for EAN-13
5. Read digit barcodes in the bellow
0 0 5
0 0 0
symbology ID
ascending
How to clear a certain 1D barcode Intersection Setting?
E.g: If you want to cancel the EAN-13 Intersection Settings, take the processing as below;
1.
Read "Enable Code Programming" bar code first
2.
Read "Clear a barcode Intersection setting"
3.
Check Symbologies ID Number table for EAN-13Code as "005"
4.
Read corresponding number barcode below
5.
Read "save" and "Disable Code Programming" codes
6.
Rules:
1. Maximum intersect 5 barcode message sections
2. Maximum value is 127 for start digital and end digital
3. Overlaps of barcode message sections are allowed and work independently.
4. Start digital and end digital determine its message section sequence. In the above example, descending
"004" and "001" determine the section sequence to be "reciprocal 4th", "reciprocal 3rd", "reciprocal
2nd", "reciprocal 1st"
5. to intersect only one digit, program start digital and end digital to be the same value
nlscan.com
0 0 1
0 0 3
the 1st digit
the 3rd digit
0 0 1
0 0 4
descending
the 4th digit
0 0 1
the 1st digit
Page 101
Advertisement
Table of Contents
