Troubleshooting - Bunn Trifecta MB Use & Care Manual

pROBLEM
Brewer doesn't turn on
Result in the cup is weak
Not all of the beverage presses
out into the cup
Brew Chamber will not come
out of the brewer or is difficult
to remove
Brew Latch will not engage or
push down
Brewer continues to heat and
Brew Button light continues to
flash
Brew Button is pressed but brew
does not start
Brew Button is pushed but
Water Reservoir doesn't empty
or some water remains in the
Water Reservoir
trifecta MB coffee and tea Brewer
®

TROUBLEShOOTING

SUGGESTIONS
• Make sure brewer is plugged into a working outlet.
• Brew Button will be illuminated or flashing if there is
power to the machine.
• Try using less water or more coffee or tea
(at least 2 grams of coffee per oz. of water or 2.5 grams
of tea per 6 oz. of water).
• See Brewing Guide.
• Brew Chamber is not fully installed. Confirm that
Brew Chamber base is pushed onto Brew Chamber
Platform with about 1/8" of aluminum rail showing.
See page 4
• Lift the Latch all the way up and gently pull out the
Brew Chamber. Clean the Brew Chamber Platform,
Air Infusion Nozzle and Brew Chamber Air Inlet with a
soft cloth and mild detergent.
• Lift Latch and make sure that Brew Chamber is fully
pushed into the Brew Chamber platform.
• You may be at a higher altitude. See page 3 to
program your machine for high altitude use.
• Make sure brewer is plugged into a working outlet.
• Make sure setup was completed. See Setting Up
trifecta on page 3.
• Make sure Water Reservoir has at least 6 ounces of
water.
• Ensure Brew Chamber is fully inserted and Latch is
engaged.
• Remove Strainer from Water Reservoir and inspect for
foreign material or any film. Perform Deep Cleaning if
film is present.
• If Brew Button flashes slowly, brewer is heating water
to proper brew temperature – wait approximately 2
minutes until the Brew Button is steady blue.
• Press Brew Button to begin brew.
• Remove Water Reservoir, put back in machine, and
confirm that Water Reservoir is seated properly.
• Lift up Latch and push back down to reset the machine.
• If problem persists, remove Water Reservoir, separate
Strainer and clean thoroughly. Replace Strainer and
Water Reservoir and run a water only Brew Cycle
to test.
11